-
The ceiling grilles are designed for air supply as well as for exhaustion. Due to the fixed lamellas they are suitable mainly for creating horizontal air flows. The specially developed fittings and pressure boxes provide optimal air flow distribution. The permissible temperature difference of the supplied air is ±10˚ С. The grilles can be mounted in premises with a height up to about 4 m. -
The electric heaters in ventilation and air conditioning equipment are designed for airflow heating. Their housing is made of galvanised sheet metal. It can be produced with a standard three-phase power supply or for low power (monophase) depending on the customer requirements. Each heater is equipped with a thermostat, mounted on the housing, to protect it from overheating. Control is required to ensure the proper operation of the heater. -
The grilles are used in the ventilation and air-conditioning system for precise airflow regulation. They are made of galvanised or aluminium special profiles in combination with polyamide components. Depending on the customer's requirements they can be equipped with an electric actuator. -
The diffusers are intended for floor and wall installation, with perimeter frame and horizontal fixed profile lamellas. The airflow can be perpendicular to the plane of the diffuser or at an angle of 15°. They are used for uniform air supply in the air conditioning and ventilation systems. The diffusers are made of anodised aluminium profiles. The connection with the air duc system is by a plenum box and flexible air ducts. -
The electric heaters in ventilation and air conditioning systems are designed for airflow heating. Their housing is made of galvanised sheet metal. The heaters are manufactured in two versions: rectangular duct EK and round duct ЕК-F. The heaters can be produced with a standard three-phase power supply or for low power (monophase) depending on the customer requirements. Each heater is equipped with a thermostat, mounted on the housing, to protect it from overheating. Control is required to ensure the proper operation of the heater. -
Due to their small total height the ceiling linear diffusers are suitable for installation in low ceiling cavities, e.g. in suspended ceilings. They provide good mixing and rapid reduction of temperature difference and the rate of supplied air. They are connected to the air duct system by a plenum box and flexible air ducts. The diffuser type TLD is intented for installation in premises with a height of approximately from 2,60 m to 4,00 m. The recommended temperature difference of the supplied air is ±10˚ С. The air supply direction can be changed in accordance with the desired room conditions. The stable airflow of the ceiling linear diffusers type TLD makes them suitable for use in systems with constant or variable volumetric flow. -
The damper is used to prevent backflow of air into the ventilation and air conditioning systems. It is made of galvanized steel. It is mounted in the air ducts only in horizontal position. -
The spiral duct grilles are esigned for air supply or exhaustion from round air ducts. The slots can be horizontal or vertical. -
The mounting elements are used for installation of ventilation, air conditioning, water supply and plumbing equipment. They are made of galvanised steel. -
The mounting elements are used for installation of ventilation, air conditioning, water supply and plumbing equipment. They are made of galvanised steel. -
The ceiling grilles are designed for air supply as well as for exhaustion. Due to the fixed lamellas they are suitable mainly for creating horizontal air flows. The specially developed fittings and pressure boxes provide optimal air flow distribution. The permissible temperature difference of the supplied air is ±10˚ С. The grilles can be mounted in premises with a height up to about 4 m. -
The ceiling grilles are intended for installation in industrial and commercia premises. They are suitable for tall premises (e.g. workshops, airports, theaters, bank halls) as well as for lower spaces with a height of more than 3,80 m (e.g. assembly workshops). The lamellas are adjustable and allow the creation of horizontal airflow under cooling and vertical flow in heating. The ceiling grilles are connected to the air ducts by means of a pressure box, which may be of a vertical or horizontal configuration.
